Very good the item arrived quicker than I expected. I only bought a pair of seatbelt stoppers, fitted one and it looks very OEM. Fitting instructions if you are not sure how to fit these, but please read anyway. (EXTREAMLY IMPORTANT) DO NOT cut a hole in your seatbelt it WILL weaken it and make it more likely to fail when you need it most. Rather, poke a SMALL hole through the centre of the seatbelt at the required height using something with a sharp point, like a thick needle to spread the fibers apart WITHOUT cutting them, only enough to make a SMALL hole, make sure the seatbelt buckle is above the hole (Hint: press the stud through so that the flat side of the seatbelt stopper faces toward the inside of the car and the nipple faces the outside) and then push the stud with the nipple on it through the webbing making sure the fibres of the seatbelt go around the nipple. This can be quite difficult but only make the hole just big enough to allow the nipple to squeeze through, I cannot stress this enough, DO NOT be tempted to cut the fibres to make the hole bigger. Take the backing plate (the one with the hole in it) and place it over the nipple and press hard, this takes considerable force, DO NOT use pliers', if necessary use two small pieces of wood or something similar that isn't going to damage the seatbelt or the stopper to allow you to press it closed, you will feel and hear? it click closed, job done, sit back and admire your handiwork it should look very OEM. REMEMBER THE SEATBELT IS THERE TO SAVE YOUR LIFE SO DO NOT DAMAGE IT.
