Spire Clips, Chimney Nuts and Edge Clips

These metal fasteners are used with screws and are normally found on underbody shields and trim covers. They are to secure items such as engine und...

These metal nuts are very widely used on Volkswagen cars and vans. The metal fastener is used to secure parts such as arch linings, undertrays, sil...

These body fasteners are often used on underbody trim and protective trays / panels.

These speed nuts or spire clips are used on quite a wide number of modern Audi cars to attach underbody shields and panels. If any of the panels ar...

These plastic nuts are used to join the edges of two panels. They are commonly used by Toyota to join the wheel arch lining to the edge of the whee...

A two-part clip that is used to attach the wheel arch lining to the wing on models including the Toyota IQ, RAV4, Previa and some models of the Ave...

These metal fasteners are normally used on underbody covers and protective panels. There will be a twist lock bolt that fits into this receiver and...

Metal speed nut used for securing plastic arch linings and underbody trim in position.

These metal nuts are very widely used on Skoda vehicles. Typical usage examples include for parts such as arch linings, undertrays, sill covers and...

These metal nuts are very widely used on the SEAT range to secure parts such as arch linings, undertrays, sill covers and bumper trims.

These clips join the wheel arch lining or splashguard to the wing. The clips fit along the edge of the lining and then allow it to be screwed onto ...

These small edge clips are used on some Ford models to secure the plastic windscreen cowl that covers the wiper motor and linkage at the bottom of ...

These edge nuts are used to attach parts such as engine undertrays, bumpers, splashguards and interior trim on Honda cars as well as fairings and c...

Small, black metal edge clips used to fasten plastic parts such as wheel arch linings and wheel arch trims. The clip fits over the edge of two piec...

Small metal edge clip normally used by SEAT for screwing in bumpers and arch linings.

These M6 nuts are normally used along the underside of the bumper or sill to attach undertrays or trims.