Mazda Car Trim Clips, Fixings & Fasteners

This is probably the most common Mazda clip we sell. These are fitted to almost all modern Mazda cars produced since 2010. The clips fit into an 8m...

These small, black 6mm clips have a wide collar and are common on interior trims and panels. They are often used on boot linings, upholstery, roof ...

This 8mm clip is very quick and easy to install and remove. They are often used for panels where access may be required such as wheel arch linings,...

These bolts are used on several Mazda models to secure bumpers, radiator panels and wheel arch linings. Each one includes a washer.

This clip is very widely used across the Mazda range. It is used on everything from interior trim panels to bumpers, engine bay shields and wheel a...

Common on several Mazda models, these clips are normally used on bumpers undertrays, sill mouldings or other large panels and shields.

Normally found on Mazda front or rear bumpers, these plastic fasteners expand when the centre pin is pushed in. They fit into a 5mm hole. The clips...

Normally used to secure wheel arch linings, splashguards, undertrays or bumpers, these simple screw fit plastic rivets are used on several differen...

These fir tree clips are used to secure the under bonnet sound proofing insulation on most Mazda cars since around 2003. The clips fit in a 5.5mm h...

Very common across the Mazda range, this clip is used to fasten and secure a wide variety of parts. Uses include Mazda MX-5 sideskirt clips, CX-3 b...

This clip is used by Mazda to secure the rubber seal that runs along the front or rear side of the bonnet. It's used on most modern Mazda cars incl...

These clips are a high quality replacement identical to the OE parts. Mazda use these plastic push fit rivets for a variety of uses. They can be fo...

Expanding screw fit rivets such as these will normally be used wheel arch linings, bumpers, under trays and sill mouldings.

These rectangular collared retaining clips are normally used for the foam bumper impact absorption panels fitted behind the bumper covers.

These clips are used around the edges of the wheel arch. They mount onto the lip of the wing and then the plastic wheel arch liner is attached when...

Small, black trim clips that fit into 6mm hole. These parts have a wider collar than average. They are simple to fit or remove and are fitted to se...

These expanding rivets are normally used to attach loose fitting panels such as wheel arch linings or splash guards. They fit into an 8mm hole and ...

These very small plastic button clips fit into a 4 to 5mm hole. They are used to secure rubber door seals or weatherstrips.

This distinctive screw fit fastener has an oval collar. The clip is normally used for windscreen cowls or scuttle panel trims. It is used on modes ...

These plastic trim clips are used by Mazda, normally on exterior parts such as bumpers, grilles or radiator shields and guide.

This is a common bonnet stay holder clip on Mazda vehicles. The bonnet support rod clips into this retainer when not in use. The clips can easily b...