Toyota Car Trim Clips, Fixings and Fasteners

This clip pushes into an 8mm square hole and is normally used to hold flexible panels such as wheel arch linings and splash guards. The centre hole...

These are one of our best-selling Toyota clips. They are used on lots of different Toyota and Lexus models. Often used for engine bay shields, the ...

These tiny push fit plastic rivets are used on interior trims, bumpers, radiator grilles and for some shields on Toyota vehicles. They are also an ...

These are common undertray, splash shield and wheel arch lining clips used on several modern Toyota models. The are used on the latest RAV4 as well...

There are several Toyota clips that all look quite similar to these. It's important to check the measurements and part number before you order. Eac...

These are used on many different Toyota and Lexus models. The clips are normally used on engine bay shields or engine covers.

Some models use a lot of these clips to attach the plastic protective mouldings that are fitted to the sides of the vehicles. There are normally a ...

This interior trim panel clip is widely used by Japanese manufacturers. The clips are normally used on door cards but will also be found on boot li...

These plastic nuts are used to join the edges of two panels. They are commonly used by Toyota to join the wheel arch lining to the edge of the whee...

These plastic rivets fit into a 7mm hole. They are used on some Toyota vehicle to attach parts such as bumpers, wheel arch linings and underbody sh...

This part is used for attaching exterior body moulding trim to several Toyota vehicles. The Toyota part number is 75397-35010 or 75395-35070 (witho...

This expanding plastic rivet is used on the Toyota GT-86 to attach parts such as the bumpers, under trays, wheel arches and some interior trim pane...

These clips have a 7.7mm diameter shaft and are used in the wheel arch lining on some Toyota models including the GT86. The clip is an expanding pu...

Plastic clip that is used to retain shields and linings normally around the wheel arches. The clips can also be used as screw grommets and so are o...

These are fitted to many different Toyota cars and vans. They are used on bumpers, side skirts, radiator grilles, spoilers, undertrays and engine s...

These long plastic grommets are used to attach parts and trims to the metal bodywork on some Toyota models. They are used on several models normall...

These are a 7mm standard push fit rivet that expands and locks when the centre pin is pushed in. They are used on several different Toyota models i...

This small screw fit plastic rivet fits into a 5mm hole and is used on many different Toyota cars. The clip is normally used for small trim panels ...

These are used on many Toyota models to secure small or lightweight trim panels such as windscreen cowls, pillar trim covers, boot lining panels an...

These small expanding plastic fasteners are used to accurately secure lightweight trim panels or corner pieces. They are used on parts such as bump...

Most often used by Toyota on wheel arch linings and shields, these clips are just a simple plastic rivet that can be used on all sorts of trims ins...

These distinctive blue moulding clips are fitted to several newer Toyota vehicles including the Mk3 Yaris, C-HR and the Mk3 RAV4. They are common o...

These plastic rivets are a replacement for Toyota part number 90467-09227. The clip has a grey centre pin and they are normally used on the undersi...

This parts are common on several models of the Yaris to secure the undertray and bumper. They are also used on some Lexus models and are interchang...

These white fasteners are used to secure the bumper alignment. They can often be snapped in a collision or become brittle as they age. They are an ...

These small clips are used along the inner edge of the bonnet tip or base to attach the rubber seal. They are used on a number of different Toyota ...

A standard push fit expanding plastic rivet which can be used for interior trim panels, dashboards, boot linings etc. The clip is used on many diff...

These are used on a number of different Toyota cars from the Auris to the Avensis and up the Lexus LFA. They can be used in many different location...

This trim panel clip is very widely used by Toyota on interior trim panels such as the pillar trims, sill mouldings and boot linings.

These little clips are used to attach the rubber seal strip that runs along the top of the radiator grille near the bonnet catch. The strip reduces...

One of many clips used for attaching the side mouldings and trims on to various Toyota models including the Land Cruiser Prado. There are a lot of ...

These 7mm plastic rivets are used on some modern Toyota models. In particular they are the Toyota RAV4 front grill clips (Mk4 2013-2018). The clips...

This clip is normally used by Subaru but is also fitted to the Toyota GT86 around the rear bumper. The clip is a simple push fit plastic rivet that...

These heavy duty fasteners are typically used for larger trim panels such as bumpers, under body shields, side skirts and wheel arch linings. The c...

These standard screw grommets fit into a square hole measuring 8x8mm. The parts are normally used to attach trim and parts to metal panels without ...

This is one of many different clips used by Toyota to affix the side moulding trim onto models such as the Land Cruiser Prado. The clips are colour...

These clips are used to attach the large plastic mouldings fitted to the doors on the RAV4 (1995-2000). The clips are each fitted with a foam seali...

identical specifications and equal in quality to the OE Toyota parts, these clips are a fraction of the cost. The clips are used to attach fabric i...

This fir tree style clip has a distinctive head with a cut out portion. The clip is used on a number of different Lexus and Toyota vehicles on upho...

These distinctive yellow trim clips are used to fit side body mouldings to the Toyota RAV4 (2000-2005). The clips are used on the rear wheel arch f...

These push fit plastic fasteners are used on a few different Toyota and Lexus models. They are typically used to attach side skirts, bumpers and wh...

This distinctive clip is one of many different coloured body moulding clips used by Toyota including on the Land Cruiser Prado and the Lexus GX470....

This type of clip is normally used on shields such as wheel arch liners, bumper trims, side skirts and mudguards.

One of many clips used for attaching the side mouldings and trims on various models of the Toyota Land Cruiser. There are a lot of different clips ...

These small plastic trim clips are used on interior trim panels and fascias. They are fitted to lugs on the back of trim panels and then they snap ...

This distinctive clip is one of many different coloured body moulding clips used by Toyota on models such as the Land Cruiser Prado and the Lexus G...

These clips are pushed into square holes and click in place to hold wheel arch linings, sill trims and engine shields. The clips can also be used a...

These are blue interior or exterior trim panel clips are used to attach door cards, side panels and boot lining trims on a number of Toyota models.