Audi A1 Fixings Trim Clips and Fasteners -Mk1 (2010-2018)

These star or Torx head screws are a suitable replacement for the parts used on many Audi cars to secure the front and rear wheel arch linings or s...

Audi use this clip to attach a range of different parts on several of their models. The clip can be found on exterior trims such as wheel arch lini...

There are two very similar clips used by Audi on most of their models. This version is 22mm long and there is also a 16mm version (Our part number ...

These are very common on modern Audi cars for underbody shields, covers and splashguards. The nuts are threaded and fit onto studs already attached...

There are two very similar clips used by Audi, Seat, Skoda and VW on most of their models. This version is 16mm long and there is also a 22mm versi...

Very common across the modern Audi range, these distinctive clips actually push in to expand and clip into place. The short stem fits into an 8mm h...

These are one of several types and sizes of screw grommet fitted to most modern Audi cars. They are used for mounting anything from number plates t...

These small plastic fasteners are used on the inner wing lining on a large number of Audi vehicles. The clip is used in conjunction with a metal T-...

These black, folding plastic clips are used around the edges of the wing and wheel arch lining on many different Audi cars. The clips are quite unu...

A common screw grommet fitted to many Audi vehicles. The clip is used throughout and example uses are wheel arch linings, pillar trims, door cards,...

These locking star washers are suitable for attaching underbody noise and heat insulation. The corrosion resistant parts are used throughout the Au...

These are common on vehicles produced by Audi. The clip is normally used to hold plastic trims in position in locations such as dashboards, door ca...

These plastic pins are used to attach the rear tow eye covers on a number of Audi and Volkswagen models. The clip twists in to lock or unlock the a...

This is one of the most common sizes of screw used by Audi for the wheel arch linings on their vehicles.

Very common across the entire Volkswagen Group of VW, Audi, SEAT, Skoda and Porsche. The clips are used with wheel arch liners, interior trims, qua...

These clips mount onto the bodywork or trim and allow a twist lock bolt to be secured. These are often used on removable access panels such as unde...

This sprung clip is very simple. The clip squeezes together to be fitted and expands once it is in place. Most Audi vehicles use these to fasten bo...

This plastic washer is used with twist lock bolts and act to hold the removable covers in place onto rear bumpers of several Audi cars. The covers ...

Small, black metal edge clips used to fasten plastic parts such as wheel arch linings and wheel arch trims. The clip fits over the edge of two piec...

A very common 16mm long black metal spring clip used for attaching fascias, pillar covers and interior trims. The fastener is common on a wide rang...

These metal springs are used to attach interior parts such as the interior pillar covers and door entrance sill trims.

These are small push fit rivets used for lightweight trim. The fastener fits into a 4.5mm hole and expands when the centre pin is inserted.

These are used by manufacturers in the VAG group including Porsche. They attach onto interior trim covers normally on the A, B or C pillars of the ...

This small set of fixings is used on some Audi vehicle to attach the rear tow eye or tow hitch cover panel. The set includes two twist lock plastic...