Products

This sprung clip is very simple. The clip squeezes together to be fitted and expands once it is in place. It is used on cars and vans across the VW...

These are a very common clips fitted to most Audi and VW cars in the last 30 years. They are a standard screw grommet and are used throughout the v...

VW use this clip on more than one of their models. It is used on the underbody shields including those around the engine, suspension and wheel arch...

The distinctive clips are used to attach some interior side trim panels and door cards. The clip has a kind of sprung head which helps to reduce ra...

These are used to fit interior door cards and some interior trim panels onto many different VW models. The clips are designed to flex and can disto...

These are a chunky push fit plastic fastener with an integrated rubber seal. They are used on lots of different models in the VW group to attach do...

These clips are used to fasten down the plastic covers that sit on top of the headlights on the T5 model vans.

Used specifically on some models of the Touareg, these clips are one of several types used to assemble the interior trims and covers on the car.

These clips are used on the VW Caddy (2004-2016), the Transporter T5 (2003-2008) and the Camper Vans (2004-2016). The clip is used on the sliding d...

Weatherstrip clips are used to hold the rubber seals that run around the openings on a cars bodywork. These are used on a lot of different VW Group...

Used on several Volvo cars to attach door card panels, these distinctive trim clips have a sprung head and rubber seal. The clip is fitted to trim ...

Widely used across the Volvo range, these clips are essential if you regularly work with Volvo cars. They replace the yellow version (30653441) and...

These are small push pin plastic rivets used on some Volvo cars and trucks. They are used for lightweight trim panels and covers.

These distinctive clips are used to secure the under bonnet insulation fitted to some models of VW T4 Transporter and Caravelle. The clips twist in...

These small black plastic trim clips are used on the VW T5 and T6 to attach the surround to the sliding door interior handle. There are two clips u...

These clips are used to secure rubber seals or lightweight trim panels in position. They are typically used in door openings.

These very small plastic button clips fit into a 4 to 5mm hole. They are used to secure rubber door seals or weatherstrips.

These small black clips are used to attach door seals and weatherstrips that run around the apertures of the vehicle. The canoe shaped end of the c...

These arrowhead plastic clips are used to secure rubber seal in position. There are commonly used on the windscreen cowl and some door seals.

A push fit plastic clip that is used to secure the weatherstrip in position on some older Audi vehicles.

These clips are a simple, quick-fit clip that pushes onto a fixed, barbed or threaded stud. They are used by Hyundai and Kia to attach wheel arch l...

These clips are a simple, quick-fit clip that pushes onto a fixed, barbed or threaded stud. They are used by Kia to attach wheel arch liners or spl...

These black plastic fasteners are used to attach the front wheel arch trims on the Land Rover Discovery 3 and Discovery 4.

Plastic clip that is used to retain shields and linings normally around the wheel arches. The clips can also be used as screw grommets and so are o...

These distinctive clips are used on some Ford cars and commercial vehicles. The clip head turns to unscrew and release the clip. They are normally ...

These clips are used on various Seat models including the Ibiza, Leon and Mii. The clip is a standard 8mm push fit rivet that is used to hold panel...

These clips are used on several Skoda cars including the Skoda Citigo. The fastener is a standard 8mm push fit rivet that is used to hold panels an...

These plastic fasteners are used on several Volkswagen cars and vans. The fastener is a standard 8mm push fit plastic rivet. These are normally use...

These are very common on Mitsubishi cars and pick up trucks. The plastic spire-type clips are normally around the edges of the wheel arch lining wh...

These distinctive clips are used by Toyota and Lexus on a wide range of different models to attach the seal at the rear of the front wing. Please s...

A common fir tree clip used by Fiat on their cars and vans. The clip fits into an 8mm hole. A typical use is to hold the wheel arch lining or splas...

These plastic nuts are used by Fiat and Alfa Romeo. They are not threaded but have sprung tabs inside which attach onto a weld stud or threaded bar...

Fitted to at least 9 different Subaru models since 2011, this 8mm black plastic push fit trim clip is normally used on the wheel arch linings. The ...

These body screws have a captive washer and are normally used on parts such as underbody shields, wheel arch linings and to fasten body panels into...

These 8mm push fit clips have a distinctive oval shaped head that pushes in to expand the pins and hold in place. The clips are used on some Ford m...

Large headed fir tree clips that are used to hold the splash shields or wheel arch linings in place on several Nissan models. The clips have a 35mm...

These clips join the wheel arch lining or splashguard to the wing. The clips fit along the edge of the lining and then allow it to be screwed onto ...

These plastic clips are normally used to secure wheel arch linings or other plastic trim panels in position. The clip pushes through the trim and i...

These small plastic fasteners are used on the inner wing lining on a large number of Audi vehicles. The clip is used in conjunction with a metal T-...

These small plastic fasteners are used on the inner wing lining on a large number of VW cars and vans. The clip is used in conjunction with a metal...

This clip pushes into an 8mm square hole and is normally used to hold flexible panels such as wheel arch linings and splash guards. The centre hole...

These pin retainer clips are used on several modern Honda models to secure the wheel arch lining in position. The pin pushes into a retainer and cl...

These black metal screws are the most common size used by Honda to secure wheel arch linings and splashguards. The screws are high quality parts id...

These metal screws are used on some Porsche models for securing the wheel arch linings, mudguards and under body shields into position.

Used on many modern Renault vehicles from new and also a supersession for parts used on older models such as the Renault 5. These clips push onto a...

These distinctive clips are used to hold and secure the splash guard liner around the wheel arch.