Produits

These body screws have a captive washer and are normally used on parts such as underbody shields, wheel arch linings and to fasten body panels into...

These plastic nuts are used on some Land Rover vehicles to hold the splashguards or wheel arch linings in position. The 10mm nuts are unthreaded an...

Large headed fir tree clips that are used to hold the splash shields or wheel arch linings in place on several Nissan models. The clips have a 35mm...

A black plastic push nut used on many modern Kia vehicles to secure the arch linings into position. The nut is not threaded but instead has barbs t...

These two part push fit clips are made from metal and plastic. The clips are typically used on parts such as wheel arch linings or for other trim p...

These two part push fit clips are made from metal and plastic. The clips are typically used on parts such as wheel arch linings or for other trim p...

These black plastic nuts push onto a 5mm diameter stud in the wheel arch. They are used on the front and rear arches of several Hyundai models.

These black metal screws are the most common size used by Honda to secure wheel arch linings and splashguards. The screws are high quality parts id...

These metal screws are used on some Porsche models for securing the wheel arch linings, mudguards and under body shields into position.

These small plastic clips fit onto threaded or barbed studs in the wheel arch. The clip push down over the stud and scures the arch lining in posit...

These clips are pushed onto on a metal bodywork stud. They are normally used on plastic parts such as arch linings, splashguards or shields.

These screws each have an 18mm captive washer. The screws are normally used for securing parts such as arch liners, splashguards or undertrays.

These black clips are used to ensure the front window stays properly aligned as it goes up and down. The clip is held in by a single pin and can be...

These small edge clips are used on some Ford models to secure the plastic windscreen cowl that covers the wiper motor and linkage at the bottom of ...

These distinctive plastic fasteners are used to secure the windscreen cowl in position on many Subaru models.

These push fit clips go into a 6.5mm hole. They have rectangular shaped collar. The clips are used by Volvo to secure the windscreen cowl or scuttl...

These push fit plastic buttons click into position and fasten the windscreen cowl and engine shields into position. This type is used on several Ho...

This clip is used at the lower end of the windscreen side trim. They are fitted to the Mk1 Volvo V60 and the Mk2 S60.